Logo

B2283 Engine Trouble Code

Meaning of B2283 engine trouble code is a kind of body trouble code and B2283 if your catalytic convertor fails completely, you eventually won't be able to keep the car running. Your gas mileage will also be terrible, so you should try and fix it as soon as you can. Unfortunately, the average replacement cost is around $2,140 and you can't do it yourself unless you're an experienced mechanic.

B2283 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for B2283 code is occuring now you should check B2283 repair processes.
Now don't ask yourself; What should you do with B2283 code ?
The solution is here :

B2283 Possible Solution:

B2283 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B2283 Code Meaning :

B 2 2 8 3
OBD-II Diagnostic Body (B) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Manifold Absolute Pressure/Barometric Pressure Circuit High Input Ignition/Distributor Engine Speed Input Circuit Malfunction Exhaust Gas Recirculation Sensor B Circuit High

The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate.

B2283 OBD-II Diagnostic Body (B) Trouble Code Description

B2283 engine trouble code is about Exhaust Gas Recirculation Sensor B Circuit High.

Main reason For B2283 Code

The reason of B2283 OBD-II Engine Trouble Code is Manifold Absolute Pressure/Barometric Pressure Circuit High Input.

B2283 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.